This tip comes from Jodee at Inspire Woodcraft. If your miter saw doesn’t have a sliding feature and you often find yourself limited by its capacity, these two tricks can help you get more out of your setup without buying new tools.
Jodee shares two simple but powerful ways to extend the cutting range of a standard miter saw. These methods don’t require modifications and can be done with common shop materials, making them ideal for beginners and weekend woodworkers alike.
Watch the full video and subscribe to Jodee’s channel:
Standard Miter Saw Limitations
A typical non-sliding miter saw has a fixed cutting depth and width. That means when you run into boards that are just a bit too wide, you’re left with incomplete cuts or awkward workarounds.
Rather than upgrade your saw or change your plans, these two techniques let you safely and accurately finish wider cuts using just your existing tools.
Tip 1: Use the Rolling Technique
The first method is called the rolling technique. It works well when your board is only slightly too wide for the blade to reach all the way through in a single pass.
Here’s how it works:
Start by making the cut normally. Once the blade reaches its full depth and you’re near the bottom of the board, stop and gently lift and roll the back edge of the board upward into the blade.
Keep the material stable and avoid shifting the board off its original alignment. This small motion brings the remaining uncut section into contact with the blade and completes the cut cleanly.
It’s a subtle adjustment but makes a big difference in how wide of a board you can safely cut with a standard miter saw.
Tip 2: Elevate the Workpiece
This second tip is pulled directly from Jodee’s miter saw manual. By raising the board off the saw’s base, you can increase how far the blade reaches across the material.
To do this:
Slide a flat, stable piece of material—like MDF—underneath the board you’re cutting. This elevation changes the cutting angle slightly, allowing the blade to reach a wider area of the board.
Measure the distance from the saw’s deck to the arbor housing, and from the fence to the front of the blade. These numbers help you determine how much elevation you need to make wider cuts possible.
As with any adjustment, make sure the board remains stable and secure before starting the saw. A steady platform is key to a safe and accurate cut.
Always Prioritize Safety
Both of these techniques are effective, but safety should never take a back seat. Wear proper eye and hearing protection, and double-check your setup before each cut.
If anything feels unstable or rushed, take a step back and reassess. These tricks are designed to help—not to shortcut safe practices.
More Practical Shop Tips
Jodee’s tips are great reminders that sometimes small techniques can solve big problems. If you’re working with limited space or equipment, knowing how to get the most out of what you already have is a huge advantage.
Support Jodee by visiting his online store here: https://inspirewoodcraft.com/collections/all.