This stunning design was built and created by Angela Marie Made, and it’s perfect for enhancing your outdoor space. This step-by-step guide will take you through the process of building a stylish and functional table.
Materials and Tools Needed
- Kreg Screws (weather resistant)
- Waterproof Wood Glue
- Kreg Jig
- Miter Saw
- Drill
- Clamps (optional)
- Speed square (optional)
- Hole Saw
- 1×6 Boards (for tabletop)*
- 1×3 Board (for spacers)*
- 4×4 Legs*
*For added longevity, use pressure-treated lumber or something resistant, such as cedar.
Step 1: Make the Initial Cuts
Start by using a miter saw to make the initial lumber cuts. For the 14 flat board cuts, create a stop block jig to ensure they are all the exact same size.
Step 2: Add Pocket Holes
Next, use a Kreg jig to add pocket holes to both ends of the tabletop, middle and side frames, flat boards, and table aprons.
Step 3: Assemble the Tabletop
Begin assembling the tabletop. To make this easier, assemble the left and right sections separately. Clamp the sides of the 1×6 table frame together using waterproof wood glue.
Step 4: Create Spacers
Cut a half-inch thick 1×3 board into 16 spacers to space your seven slat boards half an inch apart. If you find that the spacers are a bit less than half an inch, you can add an eighth-inch thick paint stick on each end for a perfect fit.
Step 5: Attach the Table Aprons
Mark the center point two and a half inches up from the table edge on one of the longer sides of the 1×6 frame. Attach the apron with wood glue and Kreg screws, and repeat this for the opposite side.
Step 6: Add Support Boards
After attaching the aprons, add two support boards centered perpendicularly over the slat boards on each side of the table, securing them with Kreg screws.
Step 7: Attach the Legs
Place the 4×4 legs next to each apron and attach them with wood glue and Kreg screws. If you want the legs to be removable, consider using corner brackets instead.
Step 8: Drill an Umbrella Hole (Optional)
If desired, mark the center point on the tabletop and drill a hole with a two-inch hole saw bit.
Step 9: Sand and Stain
Before staining, ensure all joints are sanded down to sit flush. Stain your table with an exterior stain, and use a foam brush to get into the slots.
Conclusion
Your DIY outdoor dining table is now complete! This table comfortably fits six outdoor dining chairs and is perfect for enjoying meals outdoors.
Video