This beautiful pie carrier was created by Houseful of Handmade, and it’s not only functional but also adds a touch of elegance to your dessert transportation.
Materials and Tools Needed:
- 1×12 hardwood board (Walnut, Maple)
- Plexiglass or acrylic sheet
- Dowel (Poplar or similar)
- Wood glue
- Wood screws
- Wood stain (optional)
- Food grade sealer
- Kreg Pocket Hole Jig
- Kreg Adaptive Cutting System (ACS)
- Drill and drill bits
- Sander
- Chisel (for glue squeeze out)
Step 1: Prepare Your Boards
Start by cutting your 1×12 board into the necessary pieces. You can use up some scrap hardwood by gluing together pieces of Walnut and Maple to create a unique design.
Step 2: Cut to Size
Using the Kreg ACS, trim the glued boards to an 11¼ inch width. This allows for quick and repeatable cuts.
Step 3: Create the Handle
Mark and cut angles on the top of the sideboards to mimic a traditional wooden toolbox. Then, drill a hole in the center for your dowel handle.
Step 4: Add Shelf Pin Holes
Next, use a shelf pin jig to drill holes in the sideboards. This will allow for adjustable shelf placement to accommodate pies of different heights.
Step 5: Create the Groove for Plexiglass
Mark where the groove for the sliding Plexiglass will go. Use the Kreg ACS to cut this groove into both side pieces and the bottom piece.
Step 6: Assemble the Carrier
Assemble the pie carrier using wood glue and pocket hole screws. Attach the bottom board to one side, then the top board, ensuring everything is square.
Step 7: Attach the Plexiglass
Measure and cut the Plexiglass to fit the front and back of the carrier. Pre-drill holes for tiny nails to secure the Plexiglass in place.
Step 8: Finish and Seal
Finally, apply a food-grade sealer to protect your wood. This will make your pie carrier safe for transporting delicious desserts!
And there you have it! A stunning wooden pie carrier that not only transports your pies but also displays them beautifully.