These DIY wood pantry shelves are designed and created by Angela Marie from Angela Marie Made. They are perfect for anyone looking to organize and beautify their pantry space.
Materials and Tools Needed
- 5 pieces of 1×12 wood boards (length will depend on your pantry size)
- 5 pieces of 1×2 boards (for supports and trim)
- Wood stain (Minwax Provincial is recommended)
- Polyurethane (for protection)
- Brad nailer
- Screwdriver
- Pry bar
- Circular saw or miter saw
- Stud finder
- Level
- Spackle
- Sandpaper
Step 1: Clear and Prepare Your Pantry
Begin by clearing all the items out of your pantry. Remove the current wire shelving using a screwdriver and a pry bar, as they may be anchored into the drywall. After removal, sand the back wall where the new shelves will be installed.
Step 2: Cut the Wood Shelves
Measure the length of your pantry wall. My pantry was about 29 inches long, so I cut five 1×12 boards to this size using a circular saw. Remember, your measurements will vary based on your pantry dimensions.
Step 3: Stain and Seal the Shelves
Stain your wood pantry shelves with your choice of wood stain. I used Minwax Provincial. After staining, allow the boards to dry completely, then apply two coats of polyurethane for added protection.
Step 4: Prepare the Shelf Supports
Cut the 1×2 boards for the shelf supports. For my pantry shelves, I cut five pieces at 29 inches for the back support, and five more for the front trim pieces. Additionally, cut the side supports to 9 3/4 inches long.
Step 5: Mark and Install the Shelf Supports
Use a pencil to mark where the shelves will hang on the wall. I kept the same location as the previous shelves, allowing for 11 inches between each shelf. Attach the support boards to the wall using a brad nailer, and then secure them into the wall studs with screws.
Step 6: Fill Holes and Paint
After your supports are installed, fill any holes with spackle and paint over them. I painted my pantry walls with Sherwin Williams Alabaster in an eggshell finish for a clean look.
Step 7: Attach the Shelves and Trim
Finally, place your stained wood pantry shelves on the supports. Use clamps to hold the front trim pieces in place and secure them with a brad nailer. Repeat this process for each shelf until all are installed.
Conclusion
Your DIY pantry shelves are now complete! Enjoy the beautiful and organized space.