This modern LED floating platform bed is created by ModernRemade. It’s designed to be both durable and visually appealing, making it a great addition to any bedroom.
Materials and Tools Needed
- 1 sheet of 4×8 red oak plywood
- 8 two-by-fours
- 6 two-by-twos
- 5 one-by-twos
- 30 foot pack of LED strips
- 50 foot of edge banding
- Wood glue
- Wood screws (2-inch and 3-inch)
- Clamps
- Drill
- Miter saw
- Jigsaw
- Sanding tools (220 grit sandpaper)
- Cutting guide attachment
Step 1: Cutting the Plywood
Start by setting up your workspace with a sheet of red oak plywood on some saw horses. Using a cutting guide attachment, mark and make a series of cuts to create eight boards that will form the outside rails of the bed frame. Make sure to set the depth of your cuts just below the plywood surface for a clean finish.
Step 2: Edge Banding
Apply edge banding to the top of the cut plywood boards. Use a regular household iron set to the cotton or hottest setting. Roll it on with a rubber roller or a scrap piece of wood to secure the banding in place. Trim any excess banding with a razor blade.
Step 3: Preparing for Assembly
Pre-sand all the boards using 220 grit sandpaper. Label the nicer sides as “top” and “side” to avoid confusion during assembly. Next, add pocket holes to the underside of each connecting board, spacing them six to eight inches apart.
Step 4: Glue Up
Align the boards for assembly. This can be a bit stressful, so take your time. Use clamps to hold the boards together while you secure them with pocket hole screws. If needed, use brad nails for added alignment support.
Step 5: Building the Support Skeleton
Create a support skeleton for added strength. This involves adding horizontal boards and support slats, followed by vertical boards to lock everything in place. Use the frame itself as a reference for your measurements.
Step 6: Attaching the Legs
Flip the bed frame over to determine the appropriate height for the legs. Use a speed square to mark where the legs will be attached. Glue the legs in pairs, ensuring the ugliest sides are facing inward.
Step 7: Filling Nail Holes
Fill any visible nail holes using wood filler. Make sure to choose a color that matches the wood for a clean finish.
Step 8: Creating the Headboard
For the headboard, cut out support arms using scrap wood. These will hold the headboard at a 15-degree angle. Once cut, sand down any rough edges and glue the pieces together.
Step 9: Attaching the Headboard
Drill holes in the headboard and attach it to the frame using screws. Ensure that everything is aligned correctly for a snug fit. If you encounter any issues with the threaded inserts, simple screws can be used as an alternative.
Step 10: Final Touches
Once the headboard is secured, add LED strips along the frame for a modern touch. This not only enhances the aesthetic but also provides practical lighting.
Cost Breakdown
The total cost for this project is approximately $160, which is very reasonable compared to purchasing a similar bed frame from a store. Here’s a quick breakdown:
- Red oak plywood: $50
- Two-by-fours: $40
- Two-by-twos and one-by-twos: $30
- LED strips and edge banding: $30
Video